How to Turn Off LED Indicator on Hopkins LED Breakaway Switch
Updated 10/03/2017 | Published 10/02/2017
Products Featured in This Question
Question:
Can I disconnect the LED?
asked by: Bob
0
Expert Reply:
In order to turn off/deactivate the LED indicator light on the Hopkins LED Breakaway Switch # HM20059 referenced in your question, you simply will not connect the white ground wire on the unit. If the white wire is not grounded, the LED indicator will not function but everything else will work like normal.
For a non-LED version, you can also use the Hopkins Replacement Break-Away Switch # HM20010.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Hopkins Trailer Breakaway Switch with Pin, Cable, and LED Power Indicator
- Accessories and Parts
- Trailer Breakaway Kit
- Switches
- Hopkins
more information >
Continue Researching
- Q&A: What is the Inner Diameter of Trailer Bearings L44649 and L68149
- Q&A: Replacement Power Converter Panel for WFCO 8735
- Q&A: Flat Tow Set Up For 2007 Mazda MX-5 That Does Not Need A Cross Bar
- Q&A: What is Difference Between Kenda Karrier Tires AM102210 and part number KE78KV
- Q&A: How Much Do the Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches Weigh?
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Q&A: Spare Wheel and Tire for Aluma Trailer 6310H
- Q&A: Replacement For Grease Seal 32374 For Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)