Is There A Trailer Jack Compatible With 1-1/2 Inch Hole On Vintage Trailer?
Updated 08/30/2017 | Published 08/29/2017
Products Featured in This Question
Question:
I have a vintage factory made Trailer Tow Easy under a vintage Chris Craft , the tongue jack is missing, the vertical hole hole that it would have gone thru has an ID of 1.5inch is there anything current I can adapt to this ? I can provide a photo of what is there if needed. Please advise
asked by: Anthony G
Expert Reply:
The smallest diameter jack we have with a footplate or wheel is the A-Frame Trailer Jack - Sidewind - 1,000 lbs. by Dutton-Lainson # DL22530. This is 2 inches in diameter at the top and 1-3/4 inches at the bottom, so you will need to enlarger the jack hole in your coupler. This is compatible with the Removable Wheel # DL22414 and the Removable Steel Foot with Pin # DL22541. I've attached a couple videos to assist.
Product Page this Question was Asked From
A-Frame Trailer Jack - Sidewind - 1,000 lbs. by Dutton-Lainson
- Trailer Jack
- Utility Trailer
- A-Frame Jacks
- Sidewind Jack
- 0 - 1000 lbs
- Manual Jack
- 15 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Dutton-Lainson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: Review of Lippert Trailer Brakes - Electric 12 Inch L R Trailer Brake Assemblies ABS Hubs - LC83PX
- Q&A: Bearing Kit With 25580 & 15123 Bearings For Lippert Axle
- Video: Bearing Kit, 15123/ 25580 Bearings, 10-36 Seal Review
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: A-Frame Trailer Jack - Sidewind - 1,000 lbs. by Dutton-Lainson
- Shop: B&B Top Rear Corner Trim for RV Seam - Right Hand - Black
- Shop: B&B Top Rear Corner Trim for RV Seam - Left Hand - Black
- Shop: etrailer Boat Trailer Jack w/ Footplate - Sidewind - Fixed Mount - 29-1/8" Lift - Zinc - 2.5K
- Shop: Trailer Axle w/ Electric Brakes - 4" Drop - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
- Shop: Electric Trailer Brake Assembly for Lippert ABS Hubs - 10" - Left/Right Hand - 3,500 lbs
- Video: Review of B and B Molders RV Trim - Plastic Molding - BM52ZR
- Video: Measuring To Choose The Right Trailer Axle
- Search Results: dl22530
- Q&A: Recommended Trailer Jack For Jet Ski Trailer
- Q&A: Do Nev-R-Adjust Brakes Need any Manual Adjustment
- Video: Let’s Check Out the Lippert Venture Actuator and High Speed Slide-Out Motor
- Q&A: Replacement Bearings and Seal for Lippert 3,500 Pound Axle
- Q&A: Is Trailer Wheel Hub Play Normal?
- Q&A: Video Showing How to Install a Grease Seal on a Trailer Hub
- Q&A: Recommended Trailer Jack to Replace ALKO Jack with 2 Inch Outer Diameter