What is the Outer Diameter of the Slotted End of Crank Handle RVLG-HDL
Updated 04/22/2020 | Published 08/27/2017
Question:
What is the outside diameter of the slotted end of the crank?
asked by: Anthony K
0
Expert Reply:
According to my calculations the outer diameter of crank handle # RVLG-HDL is a hair more than 3/4 inches. Its actually closer to 13/16 inches.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Need Dimensions For Manual Override Crank With Slotted Head
- Q&A: Landing Gear for a 2009 Heartland Bighorn 5th Wheel Trailer
- Q&A: What is the Weight Capacity for the Replacement Crank Extension for Lippert Spare Tire Winch?
- Q&A: Can the Lippert Tongue Jack Head Be Rotated and Realigned
- Q&A: Oil Bath Disc Brakes for Timbren Axle-Less Trailer Suspension
- Q&A: Replacing ADTH 1RV-200 Landing Gear Motor
- Q&A: Adding Brakes to a Mobile Home Axle
- Article: Stability Control for Heavy Duty Vehicles
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Best RV Roof Vents
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
Jim S.
4/21/2020
Thanks but I think it is to small. I have a handle for my old camper but looking for a spare. The one I have is 7/8 outside diameter and inside diameter is 11/16. Do you have a spare for me? Jim