Removing Rear Bumper To Install Curt Trailer Hitch # 13342 on 2007 Mercedes ML350
Updated 05/02/2011 | Published 04/29/2011 >
Question:
I cant figure out how to get the rear fascia off. I have your trailer hitch. I have taken the bolts out of the bottom and cant see how to remove the fascia. Cant see how the top of the fascia is attached.
asked by: BillMcDonald
Expert Reply:
I did some research on the internet and found that some of the bolts may be behind plastic tabs on your 2007 Mercedes-Benz ML350. The rear bumper may also have safety cables attached to the rear mud flaps. You will also have to remove a center fascia bracket that is pictured in the instructions. When you slide the rear bumper off, it will need to be slid straight back, as there are tabs that the bumper slides into to attach to the vehicle.
I have linked instructions for the Curt Trailer Hitch, part # 13342.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Q&A: Recommended Hitch for 2010 Mercedes-Benz ML350 4matic
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Video: DIY 2009 Mercedes-Benz GL-Class Installation for the Curt Trailer Hitch Receiver
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Trailer Hitch and Powered Wiring Harness Recommendations for 2007 Mercedes-Benz ML350
- Q&A: Recommendation For a Trailer Hitch That Will Fit 2006 Mercedes-Benz ML350
- Q&A: Kuat Bike Rack and Swing Away Extender Recommendations for 2021 Ford Bronco with Spare Tire
- Q&A: Trailer Hitch and Wiring for 2011 Mercedes-Benz ML350
- Q&A: Baby Moon With 9-3/8 Inch Diameter Compatibility with Dexstar Conventional Steel Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trimming Trunk Pan Cover of 2010 Mercedes-Benz M Class to Install Curt # 13342
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: How to Measure for Trailer Hitch Drop
- Article: Transmission Cooler
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Raise Your Travel Trailer Height
- Article: Determining Trailer Tongue Weight

