Which Spring Will Need to be Used with the Dexter/ Hayes/AL-KO Replacement Magnet
Updated 08/07/2017 | Published 08/04/2017
Question:
Should. I use 1 spring or both in a Dexter brake kit part # k71-104-00
asked by: Ray G
0
Expert Reply:
You will use only one spring in the Dexter Replacement Trailer Brake Magnet Kit for Dexter and Hayes / AL-KO 10" Trailer Brakes, # BP01-110.
Which spring will depend on which brake system you have. If you have the Dexter brakes you will use the spring that is applicable. If you have Hayes/AL-CO brakes you will use the spring that is applicable for that brake assembly.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Replacement Trailer Brake Magnet Kit for Dexter and Hayes / AL-KO 10" Trailer Brakes
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- Brake Magnets
- 10 x 2-1/4 Inch
- Dexter
more information >
Continue Researching
- Q&A: Where are the etrailer Bearing Kits Made?
- Q&A: How to Know When Trailer Brake Magnets are Worn Out and Need Replacing
- Q&A: Does Curt Trailer Wiring Harness Really Fit 2026 Toyota Grand Highlander without Tow Package
- Q&A: Looking for a Printable Wheel Bolt Pattern Template
- Q&A: Diode Recommendation to Prevent Trailer Battery From Backfeeding onto Vehicle Wiring
- Article: Trailer Wiring Diagrams
- Q&A: Where Do the Replacement O-Ring for Dexter Axle 10K and 12K Disc Brakes Install
- Q&A: Can Brake Parts be Replaced on Dexter 2,800 Pound Axles with Weld-On Trailer Brake Assemblies
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Most Popular Wheel Bearings
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)