Grease Seal Recommendation To Replace Seal with ID of 1.25 and Outer Diameter of 1.983

Updated 08/03/2017 | Published 08/02/2017

Products Featured in This Question

Trailer Idler Hub Assembly for 2,500-lb Axles - 5 on 4-1/2 - Qty 2

(24)

$114.06

Grease Seal - Double Lip - I.D. 1.249" / O.D. 1.983" - 2,000-lb to 2,200-lb Axles - Qty 1

(696)

$6.16

Question:

In this kit, the grease seal has an OD of 1.987 and ID of 1.50. However, I need an ID of 1.25 for my 2500 lb axle, but the one that you have listed, Part #34823 has an OD of 1.983, will they fit into the hub OK or will they be loose? I dont recon 4 thousandths would be that big of a deal but thought Id check before ordering. Thanks,

asked by: Steven M

Expert Reply:

The grease seal you need is the part # 34823. 4 thousandths of an inch is a tiny amount and realistically it's within the margin of error on the caliper you are using. This seal will work just fine and is the correct one for the hub you have.

Ideally though you need to measure again and verify that you just maybe were slightly off with your initial measurement.

expert reply by: Jameson C