Diameter of Hole Needed to Install the LED Trailer Stop/Turn/Tail Light # STL43RBX
Updated 08/01/2017 | Published 07/31/2017
Products Featured in This Question
Question:
What is the minimum size hole the STL43RBX light will recess mount into? Or what is the back side diameter? Thanks
asked by: Eddie
1
Helpful Expert Reply:
To install the # STL43RBX you'd need a hole diameter right at the size of 4-7/8 inches as that is the diameter of the portion of the light that would need to insert into the hole. The overall diameter is 5-3/4 inches.
For a pigtail harness to wire up this light you then would want the part # A45PB.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Optronics LED Trailer Light w/ Reflex Reflector - Brake, Tail, Turn - Submersible - Round - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Surface Mount
- Submersible Lights
- LED Light
- 5-3/4 Inch Diameter
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Tail Light for 2016 Rpod 179
- Q&A: Can I Replace the Bulb in ST90RB For A Brighter Bulb
- Q&A: Leveling Blocks to Replace Stromberg Carlson Base Pad
- Q&A: Recommended Slide-Out Motor Replacement For A Power Gear 532049
- Q&A: Recommended Replacement For A Dometic 630515.331 AC Rooftop Unit
- Q&A: Replacement for Dexter 8-283 Hub/Drum
- Q&A: Tire and Wheel Size to Replace 18.5x8.5-8 on Trailer
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Rooftop Cargo Carriers
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 5 Products You Need For Your Next Camping Trip (2022)