Replacement Hand Crank Compatible With Haul Master 3500 lb Electric Jack

Question

Question:

I need a replacement Emergency Detachable Hand Crank For a 3500llb Haul Master electric jack.

asked by: Delia R

0

Expert Reply:

We don't carry the Haul Master jack so I can't tell if it is a socket or a slotted crank and the pictures in the manual I find online are of no help. If it is slotted, the Replacement Manual Override Crank for Bulldog Powered-Drive Trailer Jack # BD500203 most likely will work. If it is socketed, we would need to know the socket size to make a recomendation. If it was 3/4" you could use the Lippert # LC285324

expert reply by: Jason S

0

Answer 1

Well we don't have the exact OEM replacement for your Haul-Master jack, however if it just has an 7/16" socket end, then you could just use the Replacement Manual Crank Handle for Stromberg Carlson Electric Trailer Jacks #SC94VR. This…

view full answer...

Answer 2

The fuse for the Lippert powered A-frame trailer jack, #LC285318, is in its power wire, see picture. If the fuse is not blown then it is likely a ground issue. The jack grounds through the mounting hardware and if there is corrosion build up that…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Replacement Hand Crank Compatible With Haul Master 3500 lb Electric Jack

Products Featured in This Question

Continue Researching