Trailer Hitch and Wiring for a 2017 Genesis G80

Updated 07/28/2017 | Published 07/27/2017

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(7)

$448.65

Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1

(673)

$17.46

1-7/8" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 2,000 lbs

(348)

$35.24

2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs

(348)

$37.43

Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs

(2291)

$49.46

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(3)

$53.78

Question:

Does this mount onto the existing Tow Port on the rear bumper drivers side? Can you share a video of the installation process or a manual? I would purchase if this does not require drilling

asked by: Goran K

Expert Reply:

Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" Item # C12165, which is the only hitch available for the 2017 Genesis G80, does require drilling for installation. I have included a link to the installation instructions but we haven't had that vehicle in to make a video showing installation.

If you decide to go ahead with this trailer hitch and plan on doing any towing the recommended ball mount is Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs Item # C45521. And for a ball you can use # A-80 for a 1-7/8 inch or # A-82 for a 2 inch.

And for trailer wiring you can use Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector Item # C56264. I have linked its instructions as well.

Curt also says you have to use stabilization strap # 18050 when using this hitch for any non-trailer load (such as a bike rack or cargo carrier) per their warranty requirements.