Could The etrailer 16-Gauge Steel # HP36VR Be Installed Using Bolts Instead of Welding
Updated 04/15/2011 | Published 04/12/2011 >
Products Featured in This Question
Question:
I have a small traailer for a CS 16. The trailer is 2 inch galvanized channel. Can I drill holes in the back plate and bolt the fender to the 2 inch channel? Thanks
asked by: Marty
Expert Reply:
If you wanted to use bolts to attach these Redline Trailer Fenders, part # HP36VR, to your trailer instead of welding it you could.
As long as you used enough bolts to secure this fender to your trailer you would not have a problem using bolts to install it instead of welding.
I would recommend you use Loctite Threadlocker 242, part # LT37477, on the nuts and bolts to help prevent them from vibrating loose and causing the fenders to detach from your trailer while driving.
Product Page this Question was Asked From
Single Axle Trailer Fender w/ Backing Plate - Steel - 14" to 15" Wheels - Qty 1
- Trailer Fenders
- No Step
- 14 Inch Wheels
- 15 Inch Wheels
- 9 Inch Wide
- 32 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Continue Researching
- Q&A: Recommendation for Hub/Drum Assembly and Electric Brakes for AL-KO 8480 Hub
- Q&A: How To Measure a Boat Trailer Fender Without Removing the Wheel
- Q&A: Replacement Roof Ladder for a Travel Trailer
- Q&A: Recommended 72" Long Fenders for a Tandem Axle Trailer
- Q&A: Availability of Trailer Wiring Harness for 2026 Subaru Crosstrek Hybrid
- Q&A: Replacement Hub and Drum assembly for ALKO 8480
- Q&A: Recommended Hitch for a 2026 Toyota RAV4 Hybrid
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Lighting Requirements
- Article: Most Popular Wheel Bearings
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers

