Recommended Replacement Trailer Lights and Jack

Updated 07/10/2017 | Published 07/07/2017

Products Featured in This Question

Right Angle 2-Wire Pigtail for Optronics Trailer Lights - 2-Prong PL-10 Plug - 6" Lead

(726)

$4.44

Mounting Bracket for Optronics A91, AL82, AL90, AL91, or AL191 Series Lights - Open Back - Black

(129)

$10.41

Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 10

(1182)

$12.86

Question:

Can you recommend for boat trailer submersible: #1-Red rear trailer lights, LED, to replace current ILC 285 #2-Amber side marker to replace Petersen PM147, #3 waterproof crimps, #4 - trailer jack to replace Bulldog TWS-151-DS frame welded. Can the snap ring be removed - to replace jack without having to weld a new jack base on trailer? Thanks.

asked by: Dan T

Expert Reply:

You can remove the snap ring of our Bulldog jack and leave the welded mounting bracket on your trailer. You can replace the jack with # BD151460.

The closest LED tail lights we have to yours are # 271595 for the driver's side and # 271594 for the passenger's side. They measure 7-1/2 by 3-1/2 inches with 2 inches between the mounting holes. They're submersible.

We don't have the exact clearance light either but # AL91AB is very close and I think will work for you. It's also an LED light and is 2-1/2 by 1 inches. It's subermisble as well but needs a mounting bracket # A91BOB and wiring pigtail # A46PB.

The best way to make wire connections on a boat trailer is to use Heat Shrink Butt Connectors # DW05744-10. They're the best for keeping moisture out of the wiring.

expert reply by: Charles S