Will Lippert Landing Gear Fit Trailer with Weld Stop Brackets of Different Dimensions
Published 06/22/2017
Question:
You say the distance between the two brackets needs to be 17 1/2 inch for the LC333964 system to fit my 20Cougar 5th wheel. The distance between mine is only 15 1/4 from the bottom to the top of the brackets. Thats the outside measurement, not the inside as you show on your diagram, Do I need to remove the brackets and have them welded to fit the 17 1/2? Thanks
asked by: Tony F
0
Expert Reply:
The Lippert landing gear part # LC333964 that you referenced can fit a trailer that has weld stops that are at a different dimension. Basically you would just have to have yours moved and rewelded.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Lippert Electric Landing Gear Set - 37" Lift - 6,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 37 Inch Lift
- Weld-On
- 2 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Landing Gear Follow Leg for 2003 Keystone Everest
- Q&A: Recommended Replacement Landing Jack System for 2008 Keystone Montana Mountaineer 345DBQ
- Q&A: Best Dual Motor Landing Gear Replacement for a 2020 Forest River Wolfpack 365PACK16
- Q&A: Solution for Atwood Landing Gear Jack that Has Damaged Leg
- Q&A: Replacement Heavy Duty Motor For Landing Gear On 2010 Keystone Raptor Toy Hauler
- Q&A: Determining The Correct Replacement Landing Gear For A 2005 Thor Tahoe Transport 5th Wheel
- Q&A: Replacement Landing Gear for 1998 Carriage Carri-Lite RK 732
- Article: What Do I Need To Tow A Trailer?
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Trailer Jacks
- Article: Best Landing Gear
- Article: Gooseneck to 5th Wheel Adapters
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Measure for Motorhome Steps