License Plate Light for Camper Special 1969 Ford F-250 Bumper
Updated 05/26/2017 | Published 05/25/2017
Products Featured in This Question
Question:
PM436 will this fit a camper special 1969 ford f-250 bumper 3 1/4 long
asked by: Steve J
Expert Reply:
The Peterson License Plate Light # PM436 referenced in your question has mounting holes that are 3-1/2 inches apart on center.
If you are needing a light with a 3-1/4 inch mounting dimension, I recommend the Optronics Ear Mount Trailer License Plate Light # LP51CB. The outside dimensions of this light are 4 inches long x 1-3/4 inches wide x 2-5/16 inches deep.
I have also attached a link that will take you to our available selection of license plate lights for you to look through.
Product Page this Question was Asked From
Peterson Trailer License Plate Light - Incandescent - Gray Housing - Clear Lens
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 1-3/4W Inch
- White
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will Fulton Tandem Trailer Fender # F008583 Fit Shoreland'r Tandem Axle Trailer
- Q&A: What Size Bolts to Install etrailer Jack TJA-5000-B
- Q&A: Do Nev-R-Lube Bearings Last a Long Time
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Replacement 12 Inch Brake Assemblies for Redline EB01-140 and EB01-145 From Dexter Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Recommended Custom Fifth Wheel Rail Kit For A 2014 Ford F-150 With A 5-1/2 Foot Bed
- Q&A: What is Normal Temperature Rating for Trailer Hubs
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: Anti-Rattle Devices
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller Installation on a Ford Full-Size Van