Size Socket Needed to Install Curt Hitch C14011 on a 2000 Ford Excursion
Updated 05/16/2017 | Published 05/15/2017
Question:
I saw a similar question on the factory bolts used on the 2000 Ford Excursion as compared to 2001 - 2005 model years. For installation with the Curt C14011 hitch, is the factory nuts in the frame14mm or 18mm? It sounds like the Curt hitch comes with the 18 mm bolts. Thank you in advance for your answer.
asked by: Scott H
0
Expert Reply:
The install bolts that come with the Curt Hitch part # C14011 for your 2000 Ford Excursion require an 18 mm socket.
Check out the install instructions link I attached below for more info on that.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 1200 lbs TW
- 12000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Recommended Trailer Hitch Receiver For 2000 Ford Excursion
- Q&A: Could Draw Tite Hitch # 41952 Fit on 2004 IC CE200
- Q&A: Replacing A 3,500lb Axle With A 5K or 6K Axle
- Q&A: Trailer Hitch and Wiring for a 2000 Ford Excursion
- Q&A: Hardware Size Used to Install Curt # C14011 or Torklift # TLF1006 on 2000 Ford Excursion
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Q&A: Can BulletProof Hitches 2-Ball Mount # BPH64FR be Used in Rise Position
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Wiring Diagrams
- Article: Top Gifts for Dads in 2024
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)