Can Trailer Wiring 4-Ways be Used to Power 12 Volt Lights
Updated 05/09/2017 | Published 05/08/2017
Question:
I was wondering if I could use a 4 pin trailer plug to run an LED light for my truck. The lights use a 12V source but have a positive and negative side. Can I wire this to a 4 pin? Thanks.
asked by: Stephen S
0
Expert Reply:
4-way connectors are designed to carry 12 volt power circuits. A lot of people use them to power LED light bars mounted below the tailgate so you could easily do what you are looking for. The white wire of the 4-way is typically the ground.
The part # HM48205 comes with both 4-way connectors needed so it would work well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hopkins 4-Way Flat Trailer Wiring Kit - Vehicle and Trailer Ends
- Trailer Wiring
- Trailer Connectors
- Trailer and Vehicle End Connector
- 4 Flat
- Plug and Lead
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Bumper Clearance on Curt Trailer Hitch for 2021 Toyota RAV4 LE
- Q&A: Recommended Hitch for a 2025 Toyota RAV4 Hybrid
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing The etrailer And Draw-Tite Trailer Hitches For A 2024 Nissan Murano
- Q&A: Is There a Replacement Spar Tube Assembly for Thule T2 Pro Bike Rack
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Trailer Wiring Diagrams
- Q&A: Comparing Curt, etrailer and Draw-Tite Trailer Hitch Receivers For a 2024 Ford Bronco Sport
- Q&A: Recommended Backup Camera System for 5th Wheel Trailer Flat Towing Jeep Wrangler
- Q&A: Can 2017 Subaru Forester XT Be Used to Carry 290 lb Dirt Bike
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Article: Roof Rack Information