What is the Dimension of the Recessed Housing on the Command Electronitcs # CE86FR Tail Light
Updated 02/14/2011 | Published 02/13/2011
Question:
What is the dimension for this whole light? and the recessed part.
asked by: Bob
0
Expert Reply:
I went out to the warehouse and pulled the Dual LED Trailer Tail Light # CE86FR, to measure. The Light is 9-5/8 inch long, 7" tall and 5/8" deep. It has a very thin rectangular design. This is a surface mount tail light so there is not a recessed part.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Dual LED Trailer Tail Light - Stop, Turn, Tail, Backup - Red and Clear Lens
- Trailer Lights
- Tail Lights
- Stop
- Tail
- Turn
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 9-5/8L x 7W Inch
- Red
- White
- Command Electronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Tail Light for a 2020 Jayco Redhawk Motorhome
- Article: Trailer Wiring Diagrams
- Q&A: What Light Will Replace My Light with DOT 16P2ST2 T35 16 Stamped on it for My Truck?
- Q&A: Looking For Surge Brake Actuator For Drum Brakes With Electric Lockout
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Q&A: Availability of Dexter DX6.6 Drop-N-Go Brake Actuator With Electric Lockout
- Q&A: Does 50 Amp Surge Protector Offer More Protection than 30 Amp Surge Protector?
- Q&A: Replacement Brake Actuator for 2008 Jayco Jay Series 1206
- Q&A: Replacement for Discontinued Bargman 30-91-010 and 30-91-011 Tail Lights
- Article: Best Bike Racks for Electric Bikes
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)