Can Gray Optronics Thin Line Bracket # A66PB Ground with 2 Wire Trailer
Published 04/05/2017
Question:
How does this single-wire design work? What type of surface does it need to be mounted to to be grounded? I have an enclosed trailer with exterior metal sheeting. The current wiring is 2-wire. Will this single-wire design work with my application? Thank You!
asked by: Scot
Expert Reply:
The Gray Bracket # A66PB is designed to ground through it's hardware. If the metal on your trailer where you will mount this touches the trailer frame it would be fine to just run the power to the single wire of the bracket.
Otherwise you can run your ground wire to the mounting stud of the bracket that has the gold colored strap ran to it on the side the light attaches to and you would be good that way as well.
Product Page this Question was Asked From
Gray Bracket and Single Wire Plug for Thin Line Series Trailer Clearance and Side Marker Lights
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Gray
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can I Wire 2 of the Atlas IV Vaquero Self-Contained Hydraulic Trailer Jacks Together?
- Article: Most Popular Wheel Bearings
- Q&A: Availaiblity of White Half Moon Trailer Vent
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Surge Brake Actuator to Replace Atwood 82543
- Q&A: Replacement for Atwood 82543 Surge Brake Actuator
- Q&A: Troubleshooting Dexter Brake Actuator K71-651 Keeping Brakes On
- Q&A: How Much Grease Should I Buy To Pack Wheel Bearings
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Maintenance Schedule
- Article: Trailer Lighting Requirements