Longer Stand-Offs/Support Pegs for an RV Ladder
Updated 03/27/2017 | Published 03/24/2017
Products Featured in This Question
Question:
Can I get longer standoffs for this ladder? I will need 8inch because my rv mask is indented where I will have to mount.
asked by: Paul F
0
Expert Reply:
We have some that are 12 inches long, # SC8531, but none that are 8 inches. You could trim the 12 inch ones though as long as you make a straight cut to put the end cap back on.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Surco RV Exterior Ladder - Aluminum - 84-1/2" Tall - 250 lbs
- RV Ladders
- Exterior Ladders
- Aluminum
- 7 Feet Tall
- Silver
- Surco Products
more information >
Continue Researching
- Video: Review of the Replacement Standoff for Stromberg Carlson Exterior RV Ladders
- Shop: Replacement Standoff for Stromberg Carlson Exterior RV Ladders - Qty 1
- Q&A: Replacement 5 Inch Support Leg for RV Ladder With Round Base
- Q&A: Replacement Support Pegs for RV Exterior Ladder
- Q&A: What is Correct Gap for SumoSpringsi Kit to Have
- Q&A: Is There Rebuild kit for Lippert Level Up Hydraulic Leg 8005353
- Q&A: Exterior Ladder Replacement for 30ft 2017 Thor Motorhome
- Q&A: Will Reese Under-Bed Rail Kit Fit a 2024 Ford F-250 Super Duty?
- Q&A: Will Advent Air Heat Strip Work with Advent Air Unit for Carrier Setup
- Article: How (and Where) to Connect an RV Propane Grill
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Which RV Propane Tank Size Do I Need?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Maintenance Schedule
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne