What are the Dimensions of the of the Mounting Holes for Part # AKEBRK-12L
Updated 02/28/2017 | Published 02/24/2017 >
Question:
Hi, Are the dimensions of the inner hole and the mounting holes known? Because we have a personalized trailer so we will have to see if it fits on the spindle and the mounting plate. Best regards
asked by: Bosmans J
0
Expert Reply:
The measurements for part # AKEBRK-12L are:
Inner hole where the spindle goes has a diameter of 4-7/16 inches.
The mounting holes, center on center, are 2 inches apart.
The top two holes in the 7 bolt pattern, center on center, are 4 inches apart.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Electric Trailer Brake with Dust Shield - Self-Adjusting - 12-1/4" - Left Hand - 12,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 12000 lbs
- Brake Assembly
- Self Adjust
- 12-1/4 x 5 Inch Drum
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement for Model 70LP Surge Brake Actuator
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Q&A: Troubleshooting Trailer Wiring Not Working on a 2023 Chevy Silverado 3500
- Q&A: Recommended Replacement Actuator for an TDE LP70 Actuator
- Q&A: Dexter 12,000 lb Axle Replacement Brake Assemblies
- Q&A: Recommended Brake Controller for a 2006 Kenworth T300 w/ Air Brakes
- Q&A: Inner Brake Drum Dimension of Dexter Drum 009-044-01 to Brake Dust Shield Mounting Flange
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller Installation: Starting from Scratch



