Dimensions of the Backing Plate on Redline Steel Trailer Fender HP36VR
Updated 01/23/2017 | Published 01/21/2017
Question:
Hi can someone provide the dimensions of the welded on fender back both in length and height? From the pictures it does not seem that the fender back covers the entire back area. thanks
asked by: John E
Expert Reply:
The steel backing plate on etrailer brand trailer fender # HP36VR is tack welded inside the rear lip of the fender. This backing plate, shown in the linked photo, does NOT extend all the way down to the very bottom of the fender.
I went to our warehouse to measure this rear surface for you and on the photo I have indicated several dimensions that I hope will be useful to you.
Product Page this Question was Asked From
Single Axle Trailer Fender w/ Backing Plate - Steel - 14" to 15" Wheels - Qty 1
- Trailer Fenders
- No Step
- 14 Inch Wheels
- 15 Inch Wheels
- 9 Inch Wide
- 32 Inch Long
- Steel
- Bolt-On
- Weld-On
- For Single-Axle Trailers
- etrailer
more information >
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Recommended Hitch for a 2026 Toyota RAV4 Hybrid
- Article: Trailer Wiring Diagrams
- Q&A: What Are the Dimensions of the Single Axle Trailer Fender
- Q&A: How To Measure a Boat Trailer Fender Without Removing the Wheel
- Q&A: Parts Needed to Swap Coleman-Mach Mach-C Everest With Advent AC135
- Q&A: 9" Wide x 32" long x 14" tall Slant Back Trailer Fender
- Q&A: Difference Between DX99FR and DX89FR
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Most Popular Wheel Bearings
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs