Recommended Long Ball Mount That Fits Hitch Ball with 1 Inch Shank to Use with Swagman Traveler XCS
Updated 01/16/2017 | Published 01/14/2017
Question:
hello. Im interested in the Swagman 64664 Bike Rack to be used while towing popup camper. My ball mount has a 4.5inch rise but is not long enough to accommodate this bike rack. What ball mount do you recommend. 1 inch ball shank? thanks
asked by: Dave M
Expert Reply:
I suggest using the Draw-Tite # 2736 ball mount. It measures 12 inches from the hitch pin hole to the ball hole and will work with your hitch ball that has a 1 inch shank. It also has a 3/4 inch rise.
This will give you plenty of room along the ball mount to install the Swagman Traveler XCS Bike Rack # S64664 and still let you tow your popup camper.
Product Page this Question was Asked From
Draw-Tite Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 12" Long - 5,000 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 5000 lbs GTW
- Draw-Tite
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Replacement Snap Pads Will Work With My Lippert Ground Control 3.0 9 Inch Round Feet
- Q&A: Where is the Trailer Brake Controller Plug Located on a 2021 Ford F-150
- Q&A: Will the Draw-Tite Ball Mount # 2923 Work on a 2024 Tesla Model Y with the Tow Package?
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Q&A: Manual Crank Handle Wont Lift/Lower Lippert Electric Trailer Jack
- Q&A: Solution for Lost Key for Bauer Products RV Baggage Door Slam Latch
- Q&A: Replacement For FIC RV Door Lock
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit