Mounting Hardware for Optronics Mounting Bracket
Updated 01/16/2017 | Published 01/14/2017
Products Featured in This Question
Question:
Hello, I have this exact light mount on my bass boat trailer except mine is black. I am replacing the black with the chrome. My old mounts were attached with pop rivets. It came like that from the factory. My question is.. What size and type of pop rivet should I use.
asked by: Steve H
Expert Reply:
The Optronics Mounting Bracket # A91CB grounds through the mounting hardware. So whatever hardware you use, whether screws or pop rivets, make sure it's made of a conductive metal. The hardware we generally recommend is self-tapping screws # 1131832 but pop rivets should work just fine.
Product Page this Question was Asked From
Mounting Bracket for Optronics 90 Series or 91 Series Trailer Lights - Self Grounding - Chrome
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Chrome
- Optronics
more information >
Continue Researching
- Q&A: Replacement LP Gas Detector Recommendation For Older Protechtor 2001 Series LP Gas Detector
- Q&A: Replacement Atwood 88555 8,000 Lb Weld-on Trailer Coupler
- Q&A: Solution for Easily Removable Winch for Car Hauler
- Q&A: Repair Kit for Ram Series 12000 Trailer Jack
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: Replacement Tail Lights Recommendation for a 2005 EZ Loader Boat Trailer
- Q&A: Will Atwood RV Carbon Monoxide and Propane Gas Detector # AT36681 Replace 31011
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: Which Hitches are Made in the USA
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)