Installation of the Kat's Engine Block Heater on a 2013 KIA Forte
Updated 01/10/2017 | Published 01/09/2017
Question:
So when the heater is installed do i have to take out a plug of some sort other wise how does it heat the coolant?
asked by: Ray
Expert Reply:
The Kat's Block Heater # KH11812 has different installation locations depending on the engine size of your 2013 Kia Forte.
If you have the Forte with the 2.4L engine, then the heater cartridge will be installed on the 2nd right rear hole in the engine block.
If you have the 2.0L engine the heater cartridge will be installed in the left front hole in the engine block.
The holes are pre-cast holes that the manufacturer has made in the engine block. You might have to clean the holes out before installing the heater. The holes can be clogged with dirt from everyday use of your Kia Forte. The heater will mount in a dry hole, meaning there is not contact with any engine coolant. The heater will radiate heat through the aluminum block to help in cold weather starts.
I have attached a diagram that will show the typically where to look for the mounting holes located in the engine block of you KIA.
Product Page this Question was Asked From
Kat's Heaters Custom Fit Engine Block Heater - Cartridge Style - 120V - 400 Watts
- Vehicle Heaters
- Engine Block Heater
- Cartridge Style
- 400 Watts
- Kats Heaters
more information >
Continue Researching
- Q&A: Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
- Q&A: Engine Heater for 2012 Hyundai Accent
- Q&A: Engine Block Heater For 2023 Hyundai Tucson 2.5L
- Q&A: Installation Steps For Installing That Kat's Block Heater # KH11812 In A 2012 Kia Rio 1.6L Engine
- Q&A: Is Silicone Dielectric Grease Needed When Installing A Kat's Heaters Engine Block Heater
- Q&A: Where Does Kat's Heater Install on 2021 GMC Canyon with 3.6 Liter
- Q&A: Which Location for Kat's Block Heater for 2006 Chrysler Pacifica 3.5 liter Engine