Which Side Typically Wears Out on Velcro, the Hook or the Loop Side
Published 12/06/2016
Question:
What is the most common failure on these covers, hook or loop portion of velcro? My cover is not staying attached and I dont know if the entire top needs to be replaced or just the hook portion on the rails?
asked by: Jay J
0
Expert Reply:
Typically its the loop section of a Velcro strip that wears out before the hook side as the hooks are made of a harder material. The part # TX1115174 that you referenced comes with both sides though.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement TruXedo Shur-Bond Velcro Brand Fasteners for 6-1/2' Beds -1-5/16" Wide
- Accessories and Parts
- Tonneau Cover
- Fasteners
- Truxedo
more information >
Continue Researching
- Q&A: Replacement Velcro Strip for Tonno Pro Lo Roll Tonneau Cover
- Q&A: How To Replace the Velcro Strips on a TruXedo Original Edge Tonneau Cover
- Q&A: Replacement Velcro J-Hook Strips for Tonneau Covers
- Q&A: Replacement Bow for TruXedo Lo Pro QT Tonneau Cover
- Q&A: Replacement Velcro for a TruXedo Lo Pro or Original Edge Tonneau Cover
- Q&A: What Advent Air Conditioner Set-Up Do I Need to Replace My Dometic 13,500 BTU?
- Q&A: Replacement Velcro Strips for Truxedo Tonneau Cover
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: The Best Towing Mirrors
- Article: How to Measure for Trailer Hitch Drop