Troubleshooting Powerbuilt Digital Torque Adapter Blinking Red Light and Intermittent Display
Published 09/13/2016
Question:
My power built is not working. When I set it, It goes up too 58lb. and a reading of 1.0 comes up and the light blink red. If any one can help me I will greatly appreciate the help.
asked by: Henry B
0
Expert Reply:
Hows the battery life? What you described sounds like a weak battery.
My contact at Powerbuilt recommended you replace the battery and it will start working again.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Powerbuilt Digital Torque Adapter - 1/2" Drive
- Automotive Tools
- Torque Wrench
- Wrenches
- 150 ft/lbs
- 1/2 Inch Drive
- Powerbuilt
more information >
Continue Researching
- Q&A: Parts Needed to Boat Trailer with 5,200 lb Axle Drums Brakes to Disc
- Q&A: Replacement Disc Brake Rotors and Hubs for a 2015 Road King Boat Trailer
- Q&A: What is Height of etrailer Electric Jack Above Mounting Bracket
- Q&A: Recommended Torque Wrench for Trailer Hitch Installation
- Q&A: Tools Required For Installation of B&W Companion Slider 5TH Wheel Hitch
- Q&A: Grease For B&W Companion Sliding 5th Wheel HItch
- Q&A: How Much Clearance Do I Need Above the Bed When Towing a 5th Wheel Trailer?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Anti-Rattle Devices
- Article: How to Measure for Trailer Hitch Drop
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Which Sway Control Hitch is Right For Your Trailer?