Could the CE Smith Spool Roller Assembly part # CE32100G be used with a Transom Saver
Updated 08/01/2016 | Published 07/30/2016
Question:
I am looking for a roller and bracket assembly to mount a transom saver. The fork on the transom saver that would go to the roller on the back of trailer is 3 inches wide, would the roller and bracket #CE32100G work for this purpose, or do you recommend something else?
asked by: Gene
0
Expert Reply:
Transom savers install by having one end attach to the lower section of your outboard motor and the other end goes to some point on the trailer. Typically a roller. The CE Smith Spool Roller Assembly part # CE32100G would work well for this.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CE Smith Spool Roller Assembly for Boat Trailers - Galvanized Steel and Black Rubber - 4"
- Boat Trailer Parts
- Rollers
- Spool Roller
- Rubber
- 4 Inch Long
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Possible Guide Upgrade for CE Smith 65" Guide Ons To Prevent Bending
- Q&A: How Wide Are Frame Clamps On CE Smith Post-Style Guide-Ons for Boat Trailers
- Q&A: Installing Pal Nuts On Trailer Rollers
- Q&A: Keel Roller Assembly For Attaching to 3" X 5" Tongue On Boat Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Can the Yakima Holdup # Y02433 Be used with Bikes that Have Fenders
- Q&A: Fender Kit Recommendation for Shoreland'r Trailer with 14 inch Trailer Wheels
- Q&A: Solution for Replacement Seal for 171255UC Oil Seal
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Boat Trailer Guides: Which are the Best?
- Article: Where to Position the Trailer Axle?
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure for Trailer Hitch Drop