Installing a Load Stop at Rear of 4 x 8 Foot Trailer
Updated 07/18/2016 | Published 07/16/2016 >
Products Featured in This Question
Question:
I loaded lumber on my trailer and there was no stop on the end of the trailer to keep the lumber from sliding out the end. A flat e track on the end of bed would work if I could slide a 2 x 4 on the end. Is there such a thing? There are no sides it is all flat.
asked by: Glen K
Helpful Expert Reply:
I have a solution that should work pretty well for you. I'd run a strip of E-track like # E19148 along the edges of the trailer, at least at the front and rear of the trailer.
The E-track could be used to secure the lumber using a ratchet strap like # SLLS28RER. The straps are sold individually, so you'd want at least two. At the end of the E-Track, you could use a wood beam socket like # 59149 to secure a board like you have shown in the photo. The sockets are sold individually.
Product Page this Question was Asked From
E Track Wood Beam Socket for Standard 2" Lumber - Qty 1
- E Track
- E Track Cargo Organizers
- Board Holder
- Erickson
more information >
Continue Researching
- Q&A: Can Oil Cap RG04-230 be Used as Grease Cap
- Q&A: Is There a Way to Create a Second Floor in an Enclosed Trailer Using E-Track Components
- Q&A: How to Pick Out Bearing for 10,000 lb Dexter Axle
- Q&A: Conversion Kit to Upgrade Manual Dometic Awning to Power Awning
- Q&A: Recommended Replacement For A Trimark 030-1000 RV Entry Door Lock
- Q&A: Replacement for Lippert 3,500 lb Axle on a Pace Cargo Trailer
- Q&A: Replacement Trailer Hub for the TDE 46205 with Galvanized Finish
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches


