How to Install the Valterra Waste Valve Extension Rod Kit T1046-12VP
Updated 06/27/2016 | Published 06/25/2016
Question:
I would like to extend my waste rod handle so it isnt so far under the camper. Do I need to remove the existing rod from the waste valve and use only the extension rod, or can I remove my existing handle and screw the extension rod onto the existing waste rod?
asked by: Tim
Expert Reply:
You do not have to remove the valve shaft on your waste gate valve to install the extension # T1046-12VP. The instructions for this part are as follows:
Unscrew the handle while holding valve shaft with cloth between a pair of pliers and the shaft.
Attach the extension tubes by simply threading them onto the valve shaft.
To adjust up to 2 inches longer, loosen locknut and unscrew stud counter clockwise until desired length is reached. Then retighten locknut.
Product Page this Question was Asked From
Extension Rod Kit for Valterra Waste Valve - Adjustable - 6" to 8" and 9" to 11"
- Accessories and Parts
- RV Waste Valves
- Waste Valve Parts
- Handles
- 6 - 9 Inch Long
- Valterra
more information >
Continue Researching
- Search Results: waste valve handle
- Search Results: gray tank handle
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: Replacement Lead Leg for Keystone Montana 5th Wheel Landing Gear
- Search Results: furrion cube
- Search Results: waste valve
- Video: All About the Extension Rod for LaSalle Bristol Waste Valve
- Video: All About the Lippert Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear
- Video: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System Review
- Q&A: Looking for Replacement Landing Gear Lead Leg for 2023 KZ Durango
- Q&A: Replacement Landing Gear Set Option for Jayco Eagle 5th Wheel Trailer
- Shop: Extension Rod for LaSalle Bristol Waste Valve - 12" Long
- Shop: Lippert Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear
- Shop: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Shop: Lead Jack Repair Kit for Stromberg Carlson Landing Gear
- Shop: Spring-Loaded Pull Pin for etrailer and Ram 5th Wheel Landing Gear
- Shop: Suspension Enhancement
- Search Results: waste valve handle extension
- Video: An In-Depth Look at the Valterra Bladex Waste Valve for RV Black Water Tank
- Shop: Fifth Wheel Hitch
- Q&A: Do Timbren Suspension Enhancement Springs Affect Unloaded Ride Quality
- Q&A: Is There an Extension Harness for Valterra EZ Valve Electric Waste Valve
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Video: Complete Breakdown of the Valterra Waste Valve Extension Tube with Handle
- Video: Ultimate Overview of the Valterra Waste Valve Extension Tube with Handle
- Video: Hands-On with the Extension Rod for LaSalle Bristol Waste Valve
- Q&A: Is The Spacer Always Needed With The SumoSprings SSR-307-47 On a 2016 Ram 1500
- Search Results: valterra rv waste valves
- Q&A: Where to Connect Curt Wiring 12V Hot Lead In 2026 Kia Sportage Hybrid
- Q&A: Replacement Shroud for Dometic Brisk II with Heat Pump
on Accessories and Parts
