CE Smith Boat Guide On For a Tandem Axle Trailer
Published 06/24/2016
Products Featured in This Question
Question:
Would the CES27600 be wide enough for a double axel trailer? I want to get this but want to make sure it could straddle two wheel wells. If you dont know could you provide the measurement between the two vertical posts on one side. Thank you.
asked by: Brooks P
Expert Reply:
The bunk board of the # CE27600 that you referenced is 60 inches long. That may be a bit of a stretch to get to fit around a tandem axle fender but you would need to measure yours first. Between the posts is going to be around 48 inches depending on where you drill the holes to mount the boards.
A better option may be to install two sets of the # CE27660 instead. One before and after the fenders.
Product Page this Question was Asked From
CE Smith Bunk-Style Guide-Ons for Boat Trailers - 60" Long - 1 Pair
- Boat Trailer Parts
- Guides
- Bunk-Style Guide
- 60 Inch Long
- CE Smith
more information >
Continue Researching
- Article: Boat Trailer Guides: Which are the Best?
- Q&A: Should I Use Post-Style Or Bunk-Style Guide Ons For A 24' Fiberglass Offshore Cruiser
- Q&A: How Close to the Boat Should the CE Smith Boat Guide Ons CE27600 Be
- Q&A: CE Smith Bunk-Style Guide-On Compatibility with Pontoon Boat Trailer
- Q&A: Replacement Boat Trailer Jack for 1997 Karavan Classic Trailer
- Q&A: Which CE Smith Bunk-Style Guide-Ons Work With Tritoon Boat?
- Q&A: Replacement Upright Bar Bracket for CE Smith Boat Bunks # CE27600
- Q&A: I Am Looking For 8 Foot Long Bunk-Style Guide Ons For My Boat Trailer
- Article: Trailer Maintenance Schedule
- Article: The Basics of Boat Trailer Bunks: Bunks or Rollers?
- Article: Best Boat Trailer Tires
- Article: Trailer Tire Sizing
- Article: Trailer Lighting Requirements
- Article: Brake Controller Installation: Starting from Scratch