Recommended 5-Pole Flat Trailer Connector To Replace Damaged Connector
Updated 05/18/2016 | Published 05/14/2016
Products Featured in This Question
Question:
The metal prong on my 5 flat connector piece snapped off. Is there a way to repair this without replacing the entire harness?
asked by: John B
0
Expert Reply:
If the 5-way connector you have is installed on the vehicle you can use part # HM37908. You would just cut the connector off of your vehicle and splice the # HM37908 with the length of wire you need. You can use butt connectors like part # DW05744-5 to connect the wiring.
If the connector is on the trailer then you can replace the damaged connector with part # HM47910.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 5-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 5 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Hitch Recommendation For A 2026 Honda Accord Hybrid Touring Model
- Q&A: Can a Surge Brake Actuator be Installed on a Swing Away Trailer Tongue?
- Q&A: Do You Know the Difference Between a 11033 Hub and My 11033L Hub?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Does Tie Down Get Removed to Install Hitch on 2026 Lexus RX350
- Q&A: Converting Trailer from 5-Way Connector to a 7-Way by Function
- Q&A: Which Hitch is Better for a 2025 Kia Telluride SX-Prestige X-Line? The etrailer or B&W?
- Q&A: Do You Have a Disc Brake Set for a Boat Trailer w/ a 5 on 4-/3/4 Lug Pattern?
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: How Much Does a Boat and Trailer Weigh?
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller Installation: Starting from Scratch