Can the Optronics Clearance Light part # MC95AB Install on Trailer that Has 2 Wires
Updated 05/09/2016 | Published 05/08/2016
Question:
This light is exactly what I have however, my existing light has 2 wires on it vs. one. Please advise
asked by: Brad
1
Helpful Expert Reply:
The Optronics Clearance Light part # MC95AB would still work well for you. This light grounds through the mounting hardware so what you would need to do is take the ground wire on your trailer's wiring and run it to the mounting stud of the light and then run the wire of the light to the power wire on the trailer.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Optronics Mini Trailer Clearance or Side Marker Light - Submersible - Incandescent - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- Incandescent Light
- 2-1/16L x 1-1/16W Inch
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Can The Bulb Be Replaced On The Optronics Mini Trailer Clearance or Side Marker Light MC95AB?
- Q&A: Best Replacement Actuator for a Titan Aero-6000
- Q&A: How To Measure For Replacement Overhead Springs On A Trailer Door
- Q&A: ABS Error Warning Light on 2018 Toyota Highlander When Installing Trailer Brake Controller
- Q&A: Mounting Hardware to Use with CE Smith Fender # CE19502
- Article: Trailer Wiring Diagrams
- Q&A: Will DeeMaxx 10" Disc Brakes Fit with 14" Americana Wheels?
- Q&A: LED Trailer Taillight Kit Recommendation for 2000 Ranger Boat Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Printable Trailer Bolt Hole Pattern Template