Reducer Sleeve Recommended to Install 3/4 Shank Hitch Ball in a 1 inch Diameter Ball Hole Draw Bar

Updated 04/21/2016 | Published 04/19/2016

Question:

General comment regarding website. You have everything nicely categorized except 1 thing !...I noticed that you do not have the ball mount stud hole diameter categorized like everything else. / rise / length /etc all neatly done ...but no the ball stud hole diameter till you get to the more informationinch page. It would be nice to have that info up front, instead of double or triple clicking from page to page to find out the diameter. I have a 1- 7/8 inch ball with a 3/4inch diameter shank , I was trying to find a 2inch hitch draw bar that would accept it. apparently all 2inch draw bars have 1inch ball stud holes? Thanks.

asked by: Tom

Expert Reply:

I would agree that it would be nice to have the ball mount hole diameter listed as a product category for the filters! I have a solution for your problem too! You would want the part # C21100 as this is a reducer that will allow your 3/4 inch shank ball to fit a ball mount with a 2 inch ball hole.

I linked the page that has all of the ball mounts we offer, you would need to select the drop you would need from the filters and the correct ball mounts will be listed.

expert reply by: Jameson C