Where to Find Stoplight Switch on 2007 Jeep Liberty for Brake Controller Install
Updated 04/12/2016 | Published 04/09/2016
Question:
Things went great with the brake controller install except the part about the brake stop light switch. It said it was over the brake pedal but I cant find it. I have a 2007 Jeep Liberty.
asked by: Donna W
Expert Reply:
On your 2007 Jeep Liberty, If you are referring to the red wire on the brake controller, it attaches to the wire on the stoplight switch that carries a signal only when the brake pedal is pressed. You will need a circuit tester, like # PTW2993, to find this wire. Most likely it's going to be a white wire with a green or tan tracer. See attached install video.
Normally you can pretty easily test the wires on the pedal to figure out the correct one. Sometimes you end up having to use the third brake light circuit.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Will Timbren's Work with a B&W Gooseneck Hitch on a 2012 Ford F-150
- Q&A: Suspension Enhancement Recommendation for 2003 Toyota Tundra with B and W Turnoverball
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer