Possible Replacement Trailer Bushing for 3/4inch ID X 7/8inch OD
Updated 03/31/2016 | Published 03/29/2016
Products Featured in This Question
Question:
My bushing in the center has worn out. It looks like 3/4inch ID X 7/8inch OD. Do you have replacement bushings for the center?
asked by: Jason S
0
Expert Reply:
Since the size you listed isn't a standard trailer suspension bushing you most likely are in need of a 9/16 inner diameter, 7/8 outer diameter bushing like part # TRBU11568.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Straight Equalizer for 1-3/4" Wide Double-Eye Springs - 8" Long - 3/4" Center Hole
- Trailer Suspension Parts
- Standard Equalizer
- Camper
- Car Hauler
- Utility Trailer
- Double Eye Springs
- 8 Inch Long
- Tandem Axle
- Triple Axle
- TruRyde
more information >
Continue Researching
- Shop: Nylon Bushing - 9/16" Inner Diameter, 7/8" Outer Diameter - 1-3/4" Long - Qty 1
- Q&A: What Direction Should The Band on a Leaf Springs Be Faceing
- Q&A: Do Slipper Springs Use Bushings on Both Ends?
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement Straight Equalizer for Existing 6-1/2 Inch Long Straight Equalizer
- Q&A: Determining Correct Replacement Leaf Spring For Trailer W/ 3000lb Axles and 27" Long Springs
- Q&A: Looking For 15" Trailer Wheel With 8 Lug Pattern
- Q&A: Does the Curt or Draw-Tite Hitch Block the Lift Gate Sensor on a 2025 Lexus RX 350h?
- Q&A: How to Measure a Trailer Spindle
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Most Popular Wheel Bearings