7-Way Adapter Recommendation for 2015 Jeep Wrangler for Running Power Wire to Camper
Updated 03/23/2016 | Published 03/21/2016 >
Products Featured in This Question
Question:
I have a 2015 Jeep Wrangler 2dr. I currently have a 4 pole trailer wiring harness connected. I need to add a 7 way rv style connector but dont need a brake controller. However, I am not going to add a brake controller, I just need the power for my camper. Can you tell what parts are best for my application and if there is a video and or directions. Thanks
asked by: Steve G
Expert Reply:
The adapter you need to convert your 4-way to a 7-way would be the part # 37185. This will give you the taillight signals for your trailer plus the ability to run a power wire for your camper.
The black wire of this adapter would need to get run to the positive post of your battery with 10 gauge wire like part # 10-1-1 (sold by the foot) through a circuit breaker like part # 9510.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can Redarc In-Vehicle BCDC Trailer Battery Charger be Connected at Same Time As Trickle Charger
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Front Hitch and TorkLift Tie Downs for a 2026 Ram 2500 Diesel w/a Factory Hitch
- Q&A: Recommended Built-In Convection Microwave to Replace a 0.9 Cu Ft Furrion Microwave Model FMSN09BL
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: Parts Needed to Add Brakes to Ranger Boat Trailer
- Q&A: Parts Needed to Add Brakes to 3,500 lb Trailer Axle
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure Your Trailer Wheel Bolt Pattern


