Trailer Hitch and Wiring Recommendations for 2013 Dodge Grand Caravan with Stow and Go Seats

Question

Question:

Witch hitch number is required to fit the 2013? Do you have an installation video for that application?

asked by: Kevin

0

Expert Reply:

For your 2013 Dodge Grand Caravan with Stow and Go seats I recommend Curt trailer hitch # 13364. This is a 2 inch hitch rated for 400 pounds tongue weight and 4,000 pounds gross trailer weight. I have included a link to a video showing an example installation for you.

If you plan on doing some towing I recommend etrailer ball mount kit # EBMK4. It comes with a ball mount with a 2-3/4 inch rise or 4 inch drop, interchangeable ball set, hitch pin with clip, and a storage bag.

And for trailer wiring I recommend # C56331 to add a 4-Way flat connector to the rear of the vehicle.

expert reply by: Michael H

0

Answer 1

Your understanding of the GVWR is correct...it is the total loaded weight of the trailer and the cargo. For your 2013 Grand Caravan, I do suggest a weight distribution system along with sway control because you are very close to your max capacity…

view full answer...

Answer 2

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 3

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 4

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 8

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 9

Unfortunately, I cannot tell you what wiper seal you would need for your 2004 Keystone Outback. This is not something that is known just from the RV information. It depends on your particular slide-out. The best way to determine what wiper seal you…

view full answer...

Trailer Hitch and Wiring Recommendations for 2013 Dodge Grand Caravan with Stow and Go Seats

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching