Can Switches for Ultra-Fab Power Twin II Electric Stabilizer Be Installed Inside a Class C RV
Updated 02/15/2016 | Published 02/14/2016
Products Featured in This Question
Question:
CAN I MOVE THE SWITCHES TO THE INSIDE OF THE CLASS C . IF THE WEATHER IS BAD I CAN STAY INSIDE AND OPERATE THE STABILIZER ?
asked by: Charlie
Helpful Expert Reply:
Technically, yes, you could mount the switches for stabilizer jack # UF39-941707 inside of the vehicle. The reason they are normally mounted on the outside is so you can see what is going on with the leveling.
If you mount the switches on the inside then I recommend mounting a level such as # HM05515 inside the vehicle since you can't easily see how level you are while inside the vehicle.
Product Page this Question was Asked From
Ultra-Fab Power Twin II Electric Stabilizer for Trailers and RVs - 22" Lift - 6,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Landing Gear Motor, Gear Box and Switch for Model 1A065012-02-01
- Q&A: Replacement Wiper Seals for Slide Outs
- Q&A: How to Find Replacement Awnings for a 2003 Cardinal Platinum
- Q&A: Replacement for a Dometic Duo Therm 3107541.009 on a 2003 Cardinal 5th Wheel
- Q&A: Can I Install a 4-Point Control Module to a 6-Point Lippert Ground Control and Only Use Four Jacks?
- Q&A: Replacement For Lippert 136214 Hub and Drum Assembly
- Q&A: Lift Kit that Fits 2016 Lance 1995 Camper
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Raise Your Travel Trailer Height
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Lighting Requirements