Parts Needed to Mount the Swiveling D-Ring on a Steel Deck Trailer
Updated 02/09/2016 | Published 02/08/2016
Products Featured in This Question
Question:
Do you recommend adding a backing plate when attaching these to a steel deck equipment trailer?
asked by: Larry
0
Expert Reply:
As long at you have the appropriate size bolts and hardware for the D-Ring Tie Down Anchor # RR06 you will not need the backing plate. The backing plate # BP06 wouldn't offer your D-ring anymore support than the steel frame itself would, but it could come in handy as a nice template for drilling the holes in your equipment trailer.
expert reply by:
Jackie C
0
Product Page this Question was Asked From
Brophy Swiveling D-Ring Tie Down Anchor - Bolt-On - 6-5/16" Wide - Recessed Mount - 2,000 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 2000 lbs
- Bolt-On
- Swiveling
- Recessed Mount
- Brophy
more information >
Continue Researching
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: When Braking, Trailer Pulls Hard to One Side and Causes Sway
- Q&A: Are Backing Plates Needed for Securing Vehicles with Horizontal E-Tracks
- Q&A: Recommended Trailer Hitch for 2017 BMW X5 M Sport
- Q&A: What Size Mounting Hardware is Required to Install the Trailer D-Ring Tie Down, # RR06
- Q&A: Hardware Included With The Brophy Swiveling D-Ring Anchors # RR6K
- Q&A: How Much Do the Demco Autoslider Hitches for the 2024 Chevy Silverado 2500 w/ Puck System Weigh?
- Q&A: What Does the 5 and the J Indicate on a 15x5J Trailer Wheel and ST205/75D15
- Article: Trailer Wiring Diagrams
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Ram Trailer Tow Prep Package
- Article: How to Raise Your Travel Trailer Height