Recommended Trailer Hitch with 1-1/4 Inch Receiver for 2007 Hyundai Tucson

Published 01/14/2016

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(15)

$227.56

Nylon Tube Brush - 1/2"

(538)

$11.59

Battery Post and Terminal Cleaner - Wire Brush

(15)

$5.70

Question:

Will both these hitches for a 2007 Hyundai Tuscon work with the Yakima Bighorn 4 hitch 1-1/4inch receiver? If yes is one easier to install than the other. Thanks

asked by: Kurt D

Expert Reply:

Any of the Class II trailer hitches that are confirmed to fit your 2007 Hyundai Tucson will work with your Yakima BigHorn 4 bike rack for 1-1/4 inch hitches. The Class II trailer hitches we offer that are confirmed to fit your 2007 Tucson are the Draw-Tite # 36363 and the Curt # C12126. The hitch I recommend is the Draw-Tite Class II Frame Receiver Hitch # 36363. This hitch will work well with your bike rack, but will not require the use of an additional stabilization strap like the Curt hitch.

Both of these trailer hitches will install in nearly an identical way. No drilling is required to install any of the hitches, but the exhaust will need to be temporarily lowered to access the existing weld-nuts. If any of the weld nuts did not previously have hardware installed in them, they likely need cleaned out to be able to install the hitch. You can use some spray lubricant and a brush like # 814092 or # DW00254 to clean out the weld-nuts. I have attached an installation video of the Draw-Tite # 36363 for you.

expert reply by: Victoria B