Would the Ratchet Assembly of the Pack'Em Wheel Tie-Down Kit Hit the Trailer Deck Floor
Updated 01/05/2016 | Published 01/03/2016
Question:
When installed into the chock, how much room do you need from the trailer deck to be able to actuate the ratchet mechanism?
asked by: Mike
0
Expert Reply:
The section of the strap of the Pack'Em Wheel Tie-Down Kit # PK-WTD that has the ratchet on it is at a fixed length so that means it would always be far enough from the trailer deck to allow it to fully function.
I attached a picture that shows that the portion that goes around the ratchet is stitched to the assembly so that it can not be adjusted in length.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Pack'Em Wheel Tie-Down Kit for Truck Beds and Trailers - 30" Tires - 800 lbs
- Car Tie Down Straps
- E Track Ends
- 6 - 10 Feet Long
- Wheel Net
- 1500 lbs or Less
- PackEm
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Can I Replace a Dometic 301 Toilet w/a Dometic 411 RV Toilet?
- Q&A: Options For Mounting A Spare Tire Under The Tongue Of A Trailer
- Q&A: Recommended Hardware for Erickson ATV E-Track Tie-Down Kit
- Q&A: Replacement Surge Brake Actuator for a 2012 Jayco Pop-Up Camper
- Q&A: Tow Mirror Recommendation for 2025 Toyota Tacoma
- Q&A: How to Find Correct Replacement Braking Assemblies for a 1989 EZ Loader Trailer
- Q&A: Measurements of B&W 2-5/16 Inch Hitch Ball with 1 Inch Rise
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Wiring Diagrams
- Article: How to Replace or Install an RV Roof Vent
- Article: Cargo Tie-Down Methods
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Anti-Rattle Devices