Is Bumper Fascia Cutting Required for Installation of the Curt Hitch #13251On a Jeep Grand Cherokee
Updated 07/12/2010 | Published 07/10/2010
Products Featured in This Question
Question:
does the bumper facia have to be cut out for hitch installation or is reciever below facia
asked by: larry r
0
Expert Reply:
If you are installing the Curt Class III Trailer Hitch, item # 13251, on a 2005 to 2010 Jeep Grand Cherokee (except SRT8), there will be no cutting of the fascia required to install the hitch.
If your vehicle has any aftermarket parts, then that will need to be determined at the time of installation.
Some items you may need with the Class III hitch are listed below.
Drawbar # C45010
Hitch Ball # 19260 or # 19247
Hitch Lock Kit # e99039
expert reply by:
Robert G
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 5500 lbs WD GTW
- 2 Inch Hitch
- 550 lbs WD TW
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Does The Draw-Tite Class III Hitch # 75699 Fit Under The Bumper On A 2011 Jeep Grand Cherokee
- Q&A: Solution for Carrying Motorcycle With 2013 Honda CR-Z
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Where is Provider ST205/75R15 Radial Trailer Tire Manufactured
- Q&A: Replacement Mounting Hardware For A Reese Base Rail Kit
- Q&A: Will The Yakima Hangover 4-Bike Carrier Only Work With Bikes That Have Front Suspension?
- Q&A: Hitch That Fits a 2007 Jeep Grand Cherokee Laredo
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How to Install a Brake Controller on a 2006 Jeep Grand Cherokee with Aftermarket 7-Way