Does the Rear Bumper Need to be Modified on a 2004 Jeep Liberty Sport to Install the # 13044 Hitch
Updated 07/09/2010 | Published 07/08/2010
Products Featured in This Question
Question:
is the hitch exposed under the factory standard rear bumper of a jeep liberty sport 2004, or would i have to replace it with a bumper that would allow access to the hitch?
asked by: Makx D
Expert Reply:
We have an installation video showing the Curt Class III Trailer Hitch, item # 13044, being installed on a 2006 Jeep Liberty for you to review. About 1/2 way through the video you will see the hitch raised into place and exactly how it fits below the rear fascia on the Liberty. You will not need to remove or replace the rear fascia or bumper to install this hitch.
This hitch installs into existing weld nuts and does not require modification of the vehicle. One installation tip I can give you is to make sure and clean the weld nuts thoroughly before attempting to install the new hitch mounting bolts, see video. We use the round end of a Battery Post and Terminal Cleaner - Wire Brush, item # DW00254, and a spray lubricant like the LubriMagic Green Series Biobased Spray Lubricant and Penetrant.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Size of Install Bolts Used for Hitch on a 2007 Jeep Liberty
- Q&A: Bolt Size that Comes with Curt Hitch for 2006 Jeep Liberty
- Q&A: Replacement For 11-1/2" Slipper Spring Equalizer
- Q&A: Availability Of Replacement Bearings 28580, 25580, and Oil Seal 370352 For AL-KO 10,000lb Axle
- Q&A: What are the Dimensions of a #99 Spindle
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Q&A: 2013 Toyota Sienna Hitch Recommendation for Yakima EXO System