Hole Diameter/Distance from Hole to Bottom of Foot Plate on the Ultra-Fab Footplate # UF17-940006
Published 12/17/2015
Question:
Hi, I would like to replace a missing foot on a square tube trailer jack with this foot. The steel tubing is 2inch square. The Square tube has a hole drilled for a pin to hold the foot on. What is the diameter of the hole in this foot and how far is the bottom edge of the hole from the top of the foot itself? Thanks,
asked by: Ken P
0
Expert Reply:
I pulled an Ultra-Fab Footplate # UF17-940006 from our warehouse and got the dimensions you requested. The diameter of the hole is 3/8 inches and the distance from the bottom of the foot plate to the hole is 5/8 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ultra-Fab Footplate for Landing Gear and Stabilizer Jacks - 8" x 5-3/4"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Will the TorkLift Lock and Load SideKick Cargo Tray Clear a Spare Tire w/a Honda Generator On It?
- Q&A: How Much Does TorkLift Lock and Load SideKick Weigh
- Q&A: Does Demco GM Fifth Wheel Rail Kit Adapter Have to Face Specific Direction
- Q&A: Replacement Adapter Feet and Ball for the Demco 6194 Adapter for Chevy/GMC Prep Package
- Article: How (and Where) to Connect an RV Propane Grill
- Q&A: Is The Bulldog Trailer Jack # BD178201 Available
- Q&A: Can Bent Leg On Lippert High-Speed Power Stabilizer Jack Be Replaced
- Q&A: Best Backup Camera System for Hitch Alignment and Trailer Observation
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub