Will Optronics Flush Mount Rubber Grommet A11GB Fit 1/4-Inch Thick Mounting Surface
Updated 11/30/2015 | Published 11/28/2015
Products Featured in This Question
Question:
Will these gromets work in a mounting surface thats 1/4inch thick? Thanks
asked by: Patrick B
Helpful Expert Reply:
The Optronics Flush Mount Rubber Grommet # A11GB and entire light assemblies like # MCL111AB will install just fine in a mounting surface with a 1/4-inch thickness. This grommet is made specifically for 3/4-inch Uni-Lite marker/clearance and utility lights.
If you also need grommets for trailer wiring we offer 7/16-inch inner diameter grommet # SWC8055 and 9/16-inch inner diameter # SWC8057.
Product Page this Question was Asked From
GloLight Uni-Lite Mini LED Clearance or Side Marker Light - Submersible - Round - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Can Weight Distribution System Be Used on Aluminum Trailer Frame
- Q&A: Trailer Wheel Torque Spec Chart
- Article: Trailer Lighting Requirements
- Q&A: Recommended Replacement for the Dexter BrakeRite EOH Actuator
- Q&A: Weight Capacity of Dexter P-12 SLR SN: D5287869 Axle
- Q&A: What Gauge Wires are Used Epicord 7-way Connector part # e99010
- Q&A: Replacement RV Microwave Recommendation for High Pointe EC028BMR
- Q&A: Troubleshooting Titan BrakeRite Electric Over Hydraulic Trailer Brake Actuator-Won't Build Pressure
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure Your Trailer Wheel Bolt Pattern