Where Will Hub Center of Wheel Be In Relation to Trailer Frame With Install of Timbren TASR7KS02
Updated 11/10/2015 | Published 11/09/2015
Question:
Hi, I have a question about product: TASR7KS02 Is the 4 inches between the center tube and center axle when fully loaded? Thank you in advance. Regards:
asked by: Morten T
Expert Reply:
When the Timbren Axle Less system part # TASR7KS02 is installed the center of the spindle will be 3/8 inches above the bottom of the trailer frame when unloaded. At full deflection (compression of the systems rubber springs), it will end up sitting 2-1/2 inches lower that that as well.
So it would be then 2-7/8 inches above the trailer frame.
I attached a diagram that has all of the dimensions of this system as well.
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Standard Duty - 4" Drop - 5 Bolt Flange - 7,000 lbs
- Trailer Axles
- Rubber Spring Suspension
- Standard Grade
- 7000 lbs
- Spindles Only
- Universal Fit
- Drop - 4 Inch
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Oil Bath Disc Brakes for Timbren Axle-Less Trailer Suspension
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Q&A: Replacement Stove Top Cover for a GE Range PLS624RTSS
- Q&A: Length Measurements for EZ Lube Spindle 2.25
- Q&A: Can I Go With A Higher Capacity Spring On My Keystone Trailer?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: How to Fix a Trailer Leaning Heavily to One Side
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: 2022 Ford F-250 OEM or Aftermarket Puck System for 5th Wheel Towing
- Q&A: Dexter vs. etrailer 7,000 lb Electric Trailer Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 5 Things to Know About Weight Distribution Hitches