Distance From Rear Hole to Shank Weld on Advantage SportsRack Hitch Extender
Updated 10/29/2015 | Published 10/28/2015
Question:
How deep is the 2 inch receiver section from the center of the rear most pin hole to the shank welds?
asked by: Phil N
1
Helpful Expert Reply:
From the weld of the # HE6000 to the rear most hole on the section that goes into the hitch this product measures 6 inches.
expert reply by:
Jameson C
1
click to enlarge
Product Page this Question was Asked From
Advantage SportsRack Hitch Extender for 2" Trailer Hitches - 11" Long
- Hitch Adapter
- Hitch Extender
- Bike Racks
- Cargo Carriers
- Hitch Mounted Accessories
- 11 Inch Extension
- Fits 2 Inch Hitch
- Heininger Holdings
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Hitch Extender with Anti Rattle Device for Use with Kuat Transfer V2
- Q&A: Will Kayak Carrier with 4 Inch Shank Depth Fit Advantage SportsRack Hitch Extender
- Q&A: Can Fogatti Tankless Water Heater Replace Girard Model
- Q&A: Is There A Hitch Extender For 2.5" Hitch With A 7,500lb GTW Capacity
- Q&A: Troubleshooting Hitch Extender for Jeep Wrangler For Multi-Ball Mount with Tow Hook
- Q&A: Recommended Hitch and Wiring Harness for a 2025 Mazda CX-90
- Q&A: Trailer Hitch Mounted Cargo Carrier for Carrying Beach Gear and Cornhole Boards
- Article: Best RV Roof Vents
- Article: Hitch Adapters and Extenders
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Best Bike Racks for Electric Bikes