Does an LED Third Brake Light Require a Load Resistor
Updated 06/08/2020 | Published 09/27/2015
Question:
Does the third brake light using putco plasma led need a load resistors for a 1994 ford f150
asked by: Josh T
1
Helpful Expert Reply:
The only circuits that need load resistors are the ones that flash when the blinkers or hazards are on.
A third brake light circuit would not require a load resistor like the part # DI34ZR that you referenced.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Q&A: How to Keep LED Turn Signal Lights on Toolbox From Flashing with Brake Pedal Pressed
- Article: Trailer Wiring Diagrams
- Q&A: Solution for Rapid Signal Flashing on Utility Bed with LED Lights
- Q&A: How Much Do the Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches Weigh?
- Q&A: Load Resistors to Fix Rapid Flashing LED Lights
- Q&A: How To Fix Check Trailer Rear Lamp Message On 2022 Chevy/GMC with Tailgate Light Bar
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: How to Choose the Right Trailer Hitch Class
John
6/4/2020
2006 Honda Ridgeline, I bought led third brake light but not plug and play, what do johnny need to buy to convert them to work without splicing