Are Studs on Kodiak 5 on 4-1/4 Trailer Hubs Long Enough to Install a Rotor and Aluminum Wheel
Published 09/17/2015
Question:
Are the studs on the Kodiak hub Q-HUB84545 long enough for a floating brake rotor and an aluminum wheel?
asked by: Jim S
0
Expert Reply:
Once a rotor is mounted to Kodiak hub # Q-HUB84545 the thread length of the studs will be reduced by 0.26 inches from 1.20 inches to 0.94 inches. This isn't a huge loss and provided you use the appropriate lug nuts with your aluminum wheels you should be good to go.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Kodiak Trailer Hub for 3,500-lb Axles - 5 on 4-1/2 - Galvanized Steel
- Trailer Hubs and Drums
- Idler Hub
- Standard
- L68149 / L44649
- Marine Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Kodiak
more information >
Continue Researching
- Q&A: Who Makes The Best Quality Trailer Bearings?
- Q&A: Hub for E-Z Lube Spindle on Boat Trailer
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Q&A: Dexter Hub Replacement for Hub Marked 8-248
- Q&A: Recommended Replacement For A Tie-Down Engineering Disc Brake Hub
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Recommendation for Replacing Torsion Axle on Ez Loader Boat Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Difference Between an Idler Hub and a Hub/Drum
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy