Adjusting Power To Trailer Brakes With Prodigy P2 Brake Controller When It Is Flashing 0.0

Question

Question:

When connected I get the .c. and then flashes to o.o my trailer plug wiring at plugs looks great

asked by: Jeff W

0

Expert Reply:

The 0.0 indication on the Prodigy P2 Brake Controller, part # 90885, indicates the power control or gain on the brake controller is set to 0. The 0.0 should be flashing 2 times per second.

You would just need to follow the installation instructions section for adjusting the power to the trailer to fix the problem. I have attached the installation instructions you can check out.

expert reply by: Jeffrey L

0

Answer 1

Be sure to weld in a ventilated area and of course use gloves and eye protection. Make sure that the area is clean of any paint or rust. You can clean the area with a wire brush, but I recommend getting a wire bit for your drill to really get the…

view full answer...

Answer 2

The hitch you mentioned is for pickups and not a utility bed, so the best option that may work is a universal weld-on hitch. It simply depends on the width of your frame; for example, if your frame is up to 44" wide you can use the Curt Class 5…

view full answer...

Answer 3

Hey Hoss, looks like you ordered the part #BD1824200100 from us back in December. Hows the battery on your trailer? It have a good charge on it? Is any of the wiring loose? Those are the two biggest culprits of this issue so I'd start there. Have…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 7

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 8

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Adjusting Power To Trailer Brakes With Prodigy P2 Brake Controller When It Is Flashing 0.0

Continue Researching