Removing Cap on Factory Wiring to Install Trailer Wiring Harness on a 2013 Honda Pilot
Updated 08/04/2015 | Published 08/03/2015
Question:
How do I pull off the cap on the connection point behind the rear bumper?
asked by: Jim
0
Expert Reply:
There is a little tab on the cap that you will have to push down or pull up on to pull the cap off of the connector to install a trailer wiring harness on your 2013 Honda Pilot. Sometimes a small flat blade screwdriver can be used if you can't do it easily with just your fingers.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- Factory Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Option For Replacing Failing Brake Buddy Vantage 3
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Availaiblity of White Half Moon Trailer Vent
- Q&A: 2012 Honda Pilot 7-Way Trailer Wiring Harness
- Q&A: Trailer Wiring Harness for 2014 Honda Pilot
- Q&A: Recommended Trailer Wiring Harness For 2014 Honda Pilot
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Parts Needed to Install Brake Controller in 2014 Honda Pilot
- Q&A: Can Muffler be Removed Without Removing Draw-Tite Hitch 75758 on 2018 Ford Escape
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How Much Does a Boat and Trailer Weigh?